Compare Similar ProductsSet 1 of 1
NitroOBD2 Diesel Red Power Fuel Optimization Device Chip Tuning /Remap Box
Universal Fitment For ALL Diesel Engines sold after January 1st, 2003
Model: NitroOBD2 Diesel
Voltage: 12 (V)
Working temperature: 0-60 (℃)
Installation and Calibration:
1 Pull out the car ignition key.
2 Find the OBD2 connector in your car and plug in Nitro Chip Tuning Box
3 Insert the key in the ignition and turn the key to the first stage. (Do not start the car)
4 Press the reset button for about 5 seconds. After releasing the button, just wait for a while, for about 30-54 sec. (Nitro OBD2 will communicate and connect with the ECU)
5 Start the engine.
6 Nitro OBD2 will recognise your car and your driving habits. After about 150 miles of driving Nitro OBD2 will adust itself to match perfectly to your car's fuel economy.
Where is the OBD2 connector in your car?
1 Driver's side, underneath dashboard, in the area under the steering column,
2 Driver's side, underneath dashboard,between the driver-side door and steering column area
3 Driver's side, underneath dashboard, between the steering column area and the center console
4 Driver's side, dashboard instrument/gauge area, between the steering column and center console
5 Driver's side, dashboard instrument/gauge area, between the driver-side door and steering column
6 Center console, vertical surface left of vehicle centerline
7 Center console, vertical surface right of vehicle centerline or on passenger side of center console
8 Center console, horizontal surface in front of passenger area.
1 x NitroOBD2 Diesel Chip Tuning Box Interface
1 x User Instructions