10X Wheel Arch Trim Clips Front Rear for Transit Tourneo Connect

10X Wheel Arch Trim Clips Front Rear for Transit Tourneo Connect Description

10 pcs Wheel Arch Trim Clips & 1pcs Turbine Power Turbocharger
Moderate volume and easy installation.The wind pressure is very high.Suitable for customers who need high performance improvements.Motor Length 10cm Motor Material Metal Shell Blade Metal Leaf.a.Power off first.b.Esc switch knob is screwed to the minimum position.C.To connect dc 12 volt battery.
The first step is to insert the three-needle plug into the out position of the tester.The white line is on the s-pole.There are three rows of arbitrary plugs in one row,and the knob is set to the minimum position.The second step is to weld the three rows of motor wires with the three wires adjusted by electricity without any color difference.
After welding,tape should be wrapped to prevent short circuit.The third step is to connect a DC 12 volt power supply to an electrically regulated red connection positive pole and a black connection to the negative pole.
After power on,the motor make a sound,stop ringing after a few seconds,then slowly twist the knob of the tester to start the motor,the normal operation of the wind is from the motor tail discharge,if not to indicate that the motor reversed,the need to two of the motor wires to adjust and then welding

Clips:
Material: Plastic,
Color: White
Length: 2cm,Width: 1.2cm
Height: 1.6cm
Lower Round Head Diameter: .1.5cm
Features:
100% new and high quality.
These are small, high quality plastic trim clips used by a wide range of manufacturers.
They are high quality clips.
As used for the front and rear plastic wheel arch trims.
Fit for Connect and Tourneo Models
Turbine:
Color:silver
Material:aluminum+plastic

Package Contents:
10 * Clips
1 * Turbine
1 * Instruction manual
1 * ESC

Only the above package content, other products are not included.
Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.