F722 Stack F7 Flight Controller BLS-60A 4in1 ESC 3-6S Dual BEC

F722 Stack F7 Flight Controller BLS-60A 4in1 ESC 3-6S Dual BEC Description

F722 Stack F7 Flight Controller BLS-60A 4-in-1 ESC 3-6S Dual BEC Description
The F722 is a 3-8S 36x36mm mini flight controller with 16MB flash memory and a 5V/10V dual BEC. Designed for easy maintenance and low interference.
The circuit board is made of high-quality composite material with higher overcurrent resistance and good heat dissipation.
The MOS uses a high current rating, low power consumption, and strong power handling capability.
Industrial-grade components are used, ensuring high temperature resistance. High-quality capacitors, strong filter performance
Intelligent control: The controller features an integrated low-noise button that can be remotely controlled at the touch of a button
Maximum performance: The OSD allows you to control your drone with maximum speed and accuracy while ensuring a smoother flight
Model: F722 Flight Controller
MCU: STM32F722RET6
IMU: -42688
OSD: AT7456E
Baro: SPL06-001
: 16 MB
Input voltage: 3-8S LiPo (11.4-36 V)
5V-BEC: 5 V/2.5 A 0.1 V
10V-BEC: 10 V/2 A (USER1)
IO2: USER2
Receiver: ELRS (CRSF), TBS (CRSF), SBUS.IBUS.DSM2.DSMX
UART: UART1/2/3/4/5/6
IIC: 12C1
LED Strip: YES
Buzzer: 5 VE
ESC Signal: Supports PWM, Oneshot125, Oneshot42. Multishot Dshot150, Dshot300, Dshot600
USB: Type-C
Power connector: Yes
Voltage sensor: Yes
DFU DFU button: Yes
Firmware: for Betaflight 4.3.1 JHEF7DUAL.HEX
Mounting hole: 30.5 x 30.5 x 4 mm
for TEARCKEP BLS-60A 4-in-1 ESC HV 3-6S
Aperture: 30.5 x 30.5 mm (after ball mount installation, aperture is 3 mm)
Firmware: BLHELI-S
Input voltage: LiPo 3-6S
Continuous current: 60 A
Maximum current: 65 A (10 seconds)
Processor: EF8BB21
Driver signal support: DShot150-300-600/Multishot/Oneshot/PMW
Current sensor: supported
Color: Black
Material: PCB
Package contents:
1 x F722 Stack Kit
Only the above package contents, other products are not included.
Note: Light reflections and different displays may cause the color of the item in the picture to be slightly different from the actual product. The allowable measurement error is +/- 1-3 cm.
[OnBuy.com]