New Upgraded Fuel Injector Tester Toolsand

New Upgraded Fuel Injector Tester Toolsand Description

New Upgraded Fuel Injector Tester Toolsand Description
1. 12V battery power supply
2. Working conditions: 0C - 40C; relative humidity 80%
3. Storage conditions: -20C - 50C; relative humidity 85%
4. Size: 119x79x25mm(main part)
5. Weight: About 270 g
Operating Instructions:
1. Turn off the engine of the car.
2. Remove the wire plug with the fuel injector to be tested,and then connect the two pulse output terminals of the instrument with the fuel injector of the vehicle.
3. Connect the red clip of the instrument to the positive pole of 12V automobile battery,and connect the black clip of the instrument to the negative pole of the battery.
4. "Mode set" key to select the required pulse signal output mode,and the screen display the currently mode.
Warning:
1. The engine of the car must be turned off before using this instrument.
2. Do not smoke or near the car.
3. Don' splash the fuel on the hot engine parts.
4. Use this instrument only in ventilated places. Do not inhale the exhaust gas from the car and the steam generated by the fuel flying.
5. Do not get close to the rotating (or moving) parts of any car,and do not touch the heating parts of any car.6. Do not short circuit the positive and negative electrodes of the automobile battery.
7. Do not touch any auto parts with dangerous voltage
8. Always follow the warnings,cautions and maintenance instructions in the vehicle maintenance manual.
9. Wear qualified goggles.
10. After the test,all disconnected vehicle connections should be restored correctly
Colour:black
Material:ABS
Package Contents:
1 * Fuel Injector Tester Tools
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.