STC-100A Digital Temperature Controller AC220V Int

STC-100A Digital Temperature Controller AC220V Int Description

1.Multi-purpose: The temperature controller supports the conversion of cooling mode and heating mode, which is suitable for home brewing, fermentation tanks, incubators, greenhouses and so on.
2.Multi-purpose: The digital display thermostat supports temperature control according to the temperature setpoint and return difference, and has the functions of temperature correction, sensor failure alarm and control output protection delay.
3. Basic parameters: thermohygrometer model STC-100A, temperature control range of -40-99, relay contact capacity of 10A/220V AC.
4. Easy to install: the structure of the temperature control device is clear and easy to install and dismantle. It does not require the use of complicated tools. It only takes a few minutes to complete the installation, which can effectively save your time and energy.
5.HIGH QUALITY MATERIAL: The gas detector is made of high quality plastic material, which has strong anti-interference ability and stability, high impact strength, high temperature resistance and can be used for a long time.

Front panel size:77x34.5(mm)
Sensor wire length:2 metres (including probe wire length)
Installation hole size:71x29 (mm)
Power supply:220V AC+10%/-15%,50/60Hz
Relay output capacity: 10A/220V AC can be directly driven single-phase 0.5HP/220V AC and the following loads
Power consumption: less than 3W
Control Range:-40-99
Measuring range:-40-99
Temperature Resolution:1
Temperature measurement accuracy: 10.5
Sensor failure delay: 1 minute
Front panel protection grade: IP54
Sensor type: sensor
Operating Temperature:0-60
Storage Temperature:-30C-75C
Relative humidity:20%-85% (no condensation)
Colour:Photo Color
Material:plastic

Package Contents:
1 x Thermostat
1 x Probe

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.