Anti Spark Switch 200A 3S-20S PCB Board for Scooter / Robots

Anti Spark Switch 200A 3S-20S PCB Board for Scooter / Robots Beschrijving

Anti Spark Switch 200A 3S-20S PCB Board for Scooter / Robots Description
Aluminum pcb Features: MOS fets: use 10x10 large package MOS , with better overcurrent and heat dissipation performance
Control mode: lock key control switch mode; press the lock button to lock it to open, and the LED light light up at the same time, press the lock button again to bounce it to turn off, and the LED light turn off at the same time.
The function of the product: the aluminum substrate fire-proof spark switch efficiently and safely protects the power contacts from being burnt and oxidized by the electric spark, effectively protecting the electronic components of the integrated circuit from breakdown and damage, preventing the occurrence of electric that may cause an explosion, and more effectively extending the electronics Product life.
Aluminum base plate has better heat dissipation performance. It is more convenient to add a larger heat sink for continuous large current output. The heat sink and the heat sink are connected with thermally conductive silicone grease, which has a better heat conduction effect.
Due to different batches,the appearance,color and printed words of the product , which not affect the use
Maximum current:200A (maximum current 200A requires enlarging the heat sink)
Continuous current:80A (with factory housing) LED button diameter:12mm
Voltage:12-90V (3S-20S)
current (Less than10MS):1000A (theoretical value)
Warnings:
Do not peel off the heat shrink.There's no screw to lock the heatsink and PCBA,Only the heat-transfer silicon pad is naturally sticky to heatsink and PCBA.
No short circuit protection,DO NOT short circuit output!
No reverse polarity protection. DO NOT plug in backwards
Recommended to keep output capacitance under 6,000 uF.Proper operation cannot be guaranteed at higher capacitances
Do not Hot-Swap.Try to make sureeverything is off before connecting and removing.If need be,unplug from battery first,wait for ESCs to turn off, then unplug ESCs.Do the reverse for plugging in,plug in ESCs first before plugging the switch into the battery
Engineers have thoroughly tested ;however,this is still a new design and a first production run, please exercise extreme caution (as one would normally do with any electric vehicle) when using this device
Do not attempt to reprogram the MCU unless otherwise advised. Doing so void any and also put the switch at great risk of failure
Material: Aluminum alloy
colour: Black
Package Contents:
1 x Anti Spark Switch
Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.