For Raspberry Pi Zero 2.13 Inch Multifunctional Portable Touch Ink Screen 250X122 Resolution with Case

For Raspberry Pi Zero 2.13 Inch Multifunctional Portable Touch Ink Screen 250X122 Resolution with Case Popis

1. 2.13-Inch Capacitive Touch Ink Screen, 250x 122 Resolution
2. Supports 5-Point Touch And Custom Gesture Wake-
3. No Backlight Is Required, And The Display Content Of The Last Screen Can Be Maintained For A Long When The Power Is Turned Off.
4. The Power Consumption Is Very Low, Basically Only Consuming Power When Refreshing.
5. Based Raspberry Pi40pin Gpio Interface Design, Suitable For Raspberry Pi Zero / Zero W And Other Two Main Control Boards

1. Working Voltage: 3.3V
2. Communication Interface: 3-Wire Spi, 4-Wire Spi
3. Partial Refresh: 0.3s
4. Overall Dimensions: Approximately 69.15 x 38.90mm
5. Display Size: About 48.55x23.70mm
6. Global Refresh: 2s
7. Refresh Power Consumption: 26.4mw(Typ.)
8. Point Pitch: 0.194x0.194mm
9. Sleep Current: Less than 0.01ua (Near 0)
10. Resolution:250*122pixels
11. Viewing Angle:Greater than 170
12. Touch Points: 5
13.Colour:As Shown
14.Material:ABS
Note:
Different Batches May Have Differences In Product Appearance, Color, And Printed Characters, Which Will Not Affect The Use

Package Contents:
1 x 2.13-Inch Touch Electronic Screen
1 x Upper And Lower Shell
1 x Screwdriver
1 x Thermal Conductive Silicone Sheet
4 x Anti-Slip Rubber Particles
2 x Flat Screws