20Set BMI160 GY-BMI160 6-Axis Rate Gyro Gravitation Accelerometer Sensor Module IIC I2C SPI Communication Protocol 3-5V

20Set BMI160 GY-BMI160 6-Axis Rate Gyro Gravitation Accelerometer Sensor Module IIC I2C SPI Communication Protocol 3-5V Beskrivelse

Product introduction: The module uses for 's new BMI160 6-axis inertial motion sensor in a MEMS sensor package that integrates the top 16-bit 3-axis accelerometer with an ultra-low-power 3-axis gyroscope.
The module can output acceleration data (acceleration values detected by the device in the X, Y, and Z directions) and gyroscope data (the speed at which the device rotates around the X, Y, and Z axes). When accelerometers and gyroscopes operate in full-speed mode, typical power consumption is as low as 950μA, which is only 50% or less of the power consumption of similar products the market.
Designed for smartphones, tablets, and wearable devices, for the BMI160 includes a built-in step counter algorithm that reads the number of steps directly through the registers.
The built-in 3-axis acceleration and 3-axis gyroscope enable motion detection such as running and fitness. Module built-in LDO power management chip, VIN supports 3.2~6V wide voltage supply, also has a separate 3.3V interface, compatible with for 3.3V and 5V controller direct drive.

Application scenario:
1. Walking step
2. Acceleration detection
3. Dip measurement
4. Display horizontal / vertical mode
Technical specifications:
Working voltage: 3.2V~6V
Current consumption: Less than1mA
Interface mode: 2.54 pitch pin header
Acceleration optional scale: 2g/4g/8g/16g
Gyro optional scale: 125/s, 250/s, 500/s, 1000/s, 2000/s
Accelerometer zero drift: 40mg
Gyro zero drift: 10/s
Programmable frequency: 25/32Hz~1600Hz
6D detection and positioning
16-bit data output
Impact resistance: 10, 000 gx 200μs
2 independent programmable interrupt generators
Built-in 1024 byte FIFO
Working temperature: -40C ~ +85C
Material: PCB
colour: As Show