3000W Instant Water Heater110V for Kitchen & Bathroom

3000W Instant Water Heater110V for Kitchen & Bathroom Beskrivelse

Item Type: Instant Water Heater Heating Body: Aluminum Die Casting Weight: Approx. 1900g / 4.2lb Voltage: 110V (US Standard) Power: 3000W Frequency: 50-60HZ Wire: 2.08 Waterproof Grade: IPX4Product Size: Approx. 21x15x5.5cm / 8.3x5.9x2.2in Remote Control Power Supply: 2AAA Batteries (Not Included) Temperature Range: 30-55C Common Faults and Solutions: 1. Check whether the power supply is powered on normally, the indicator light on the power‑on display will light up to show the temperature, and it will not light up if it is not powered on. 2. Under normal power on conditions, the water flow is turned on, press the middle switch key, the machine starts heating, and the water heater displays: set temperature, water flow, outlet temperature. 3. If the temperature does not rise, there are two possibilities: one is that the temperature control switch (overheat protection switch) inside the water heater jumps, press the temperature control switch to restore it. The other is that the heating pipe is faulty, and the heat pipe can be replaced. 4. If there is a display of no heating, the display shows the temperature, but the water flow and set temperature are not displayed, indicating that the water flow does not pass through the water heater, or the water pressure is too low, or the installation direction is wrong. Note that the water inlet and outlet must be installed correctly, but if the water If the pressure is enough, there is water flow and it does not heat, then check the turbo at the water heater inlet, there may be something stuck in the turbo, causing the water heater not to start. 5. It is recommended that the length of the water pipe at the water heater outlet should not exceed3meters. If it exceeds the length of the water pipe, there may be a water pressure difference, and the water pressure is not enough to start. (If the water tower is used in rural areas, the height of the water tower is required to be higher than10meters, so that the water pressure reaches the start value). .wang-edit-text{ font-family: 'Arial' !important; } .wang-edit-text table { border-top: 1px solid #000; border-left: 1px solid #000; } .wang-edit-text table td, .wang-edit-text table th { border-bottom: 1px solid #000; border-right: 1px solid #000; padding: 3px5px; } .wang-edit-text table th { text-align: center; }