F7 V3 BL32 50A 30x30 Flying FC+ESC

F7 V3 BL32 50A 30x30 Flying FC+ESC Beskrivelse

Name:F7 V3 Flight Controller. MCU:STM32F722. IMU(Gyro):SBMI270. USB Port Type:SType-C. Barometer:SBMP280. OSD Chip:SAT7456E chip. BLE :Supported. Used for Flight Controller configuration
Flash ESC+ESC Firmware Wirelessly:SSupported. Please enter MENU Greater than ESC+ESC Firmware Flasher. Download/Analyze :Supported.Please enter MENU Greater than Analyzer. for Air Unit Connection Way:Two ways supported: 6-pin connector or direct soldering.
Flash(for ):500MB. BetaFlight Camera Control Pad:Yes(CC pad the front side). Power Input:3S - 6S Lipo

UART:
5 sets(UART1, UART2, UART3, UART4(For FC+ESC Telemetry), UART6)
ESC Telemetry UART:R4(UART4)
I2C:Supported. SDA & SCL pads front side. Used for magnetometer, sonar, etc.
LED Pad:Used for WS2812 LED controlled by Betaflight firmware.
Buzzer:BZ+ and BZ- pad used for 5V Buzzer
BOOT Button:Supported.
[A]. Press and hold BOOT button and power the FC+ESC at the same will force the FC+ESC to enter DFU mode, this is for firmware flashing when the FC+ESC gets bricked.
[B]. When the FC+ESC is powered and in standby mode, the BOOT button can be used to controller the LED strips connected to LED1-LED4 connectors the bottom side. By default, short-press the BOOT button to cycle the LED displaying mode. Long-press the BOOT button to between LED mode and BF-LED mode. Under BF-LED mode, all the LED1-LED4 strips will be controlled by Betaflight firmware.
RSSI Input:Supported. Named as the front side.
SmartPort:Use any TX pad of UART for the SmartPort feature.
Supported Flight Controller Firmware:BetaFlight(Default), EMUFlight, INAV
Specifications: C:F7 V3 Flight Controller + 50A ESC
Color: As shown
Material: PCB

Package Contents:
1 * Module