Mosiee12V Dual Battery Isolator Voltage Sensitive Relay

Mosiee12V Dual Battery Isolator Voltage Sensitive Relay Beskrivelse

features: 1. The installation is simple and suitable for the medium voltage sensing split charging relay system that can safely charge75A to120A leisure batteries. 2. The voltage sensing relay only detects the voltage rise in the vehicle charging system, so that you can charge the leisure battery when the engine is running. 3. When the engine is turned off, the relay will separate your leisure battery from the main starter battery. Therefore, it will not drain the battery of the main starter, and you will always be able to start the vehicle. 4. This tool kit is applicable to campers, motorhomes, 4x4s, Day Van, mobile workshops, cars or ships. 5. Add soldering points to enhance heat dissipation When the engine is started, the starting battery and auxiliary battery are separated, and only the starting battery is allowed to be charged. When the charging voltage reaches13.3V, the VSR is engaged to charge the starting battery and auxiliary battery. This is indicated by the red indicator light on the top of the LH. When the engine stops running and the battery voltage drops below12.8volts, the VSR disengages, separating the starting battery from the auxiliary battery. The auxiliary battery will continue to power all accessories without consuming the power of the starting battery. The VSR is "dual induction", which can sense the voltage of two batteries. This is very useful because it is dual induction (two-way). You have connected the battery charger or solar energy to the auxiliary battery and the battery is fully charged. The VSR will then allow your charging source to recharge the crank battery and fully charge it, but again, if the voltage drops below12.8V, the VSR will disconnect (isolate) the battery again. Specifications: Type: voltage sensitive relay Continuous current: 140A Maximum current: 160A Consumption current - charging: 280mA Current consumption - standby: 8mA Disengagement delay: 5-10seconds Recommended fuse: 80Amp Power stud: M6stainless steel Surge protection: built-in Package product weight500g Package size18 * 18 * 7cm Package includes: 1 * 12V140A voltage detection split charging relay1 * Cable30cm black1 * Cable30cm red line1 * Cable60CM red line3 * 16-6terminal Velcro2pieces per set2red heat-shrinkable tubes1 * Small black wire terminal in isolator4 * Set screw