Tuotekuvat
Valitettavasti tämä tuote on tilapäisesti loppu varastosta.
3X TDA7294 Mono 100W Power Amplifier Board Finished Board
Uusi
Samankaltaiset tuotteet, joista uskomme sinun pitävän
Haluatko meidän ilmoittavan sinulle, kun se on taas saatavilla?
Kuvaus ja tiedot
Yhteenveto
- 1. The noise of the switch is small and will not have too much impact on the speaker. It is recommended to add a horn protection circuit. The horn protection circuit can not only eliminate the impact noise of the power amplifier switch machine, but also avoid the output DC burning the horn when the power amplifier is damaged.
- 2. The bottom noise is small. Zero floating small, do not need to do any debugging after installation, the output zero drift voltage will generally not exceed 50mv, and is relatively stable.
- 3. Free debugging. As long as the connection is correct, no one is wrong, basically it is a success, no need to do any debugging, beginners also have a very high success rate.
- TDA7294 Finished board
- Amplifier board
3X TDA7294 Mono 100W Power Amplifier Board Finished Board Kuvaus
1. The noise of the is small and will not have too much impact the speaker. It is recommended to add a horn protection circuit. The horn protection circuit can not only eliminate the impact noise of the power amplifier machine, but also avoid the output burning the horn when the power amplifier is damaged.
2. The bottom noise is small. Zero floating small, do not need to do any debugging after installation, the output zero drift voltage will generally not exceed 50mv, and is relatively stable.
3. Free debugging. As long as the connection is correct, no one is wrong, basically it is a success, no need to do any debugging, beginners also have a very high success rate.
Note:
1.2SC5200 + ZSA1943 are disassemble parts,but in good condition.
2.The PCB board has change to black, but the function is same.
Operating voltage: Dual 10 - 45V recommended Dual 35V
Rated output power: 100W(4 Ohm 35V)
Maximum output power: 150W (4 Ohm 45V) enormous heat, is not recommended
PCB size: 30 x 50 x 35mm
Pitch: 5.08mm
Hole distance between two power tube: 47mm
color:As shown
Material:PCB
Package Contents:
3 x Amplifier board
Tiedot
| OPC | PYMYNV9 |
|---|---|
| Koodit | 6032016551164 (EAN) |
| Tuote- ja turvallisuustiedot |
Tuotetiedot
| Height | 6cm |
|---|---|
| Width | 8cm |
| Length | 10cm |
| Weight | 0.1035kg |
| Colour | As shown |
| Material | PCB |
Haluatko meidän ilmoittavan sinulle, kun se on taas saatavilla?
3X TDA7294 Mono 100W Power Amplifier Board Finished Board
Uusi
Saattaisit pitää myös näistä