Λυπούμαστε, αυτό το προϊόν είναι προσωρινά εκτός αποθέματος.

10X Solar Lipo Charger Board CN3065 Lithium Battery Charger Board Module

Νέο

15,24 €

Θα θέλατε να σας ενημερώσουμε πότε θα επιστρέψει;

Προσθήκη στο καλάθι

Περιγραφή & Λεπτομέρειες

Περίληψη

This is a super mini Solar Lipo charger based on the CN3065 - a single lithium battery charge management chip.
This Solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargable LiPo battery. Set-up is easy as well, just plug your solar panel into one side of the Solar charger and your battery into the other and you are good to start charging!
The output of the Solar Charger is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It's recommended that batteries not be charged at greater than their capacity rating.
CN3065
Lithium Battery Charger Board

10X Solar Lipo Charger Board CN3065 Lithium Battery Charger Board Module Περιγραφή

This is a super Solar Lipo charger based the CN3065 - a single lithium battery charge management chip.
This Solar charger provide you with the ability to get the most possible power out of your solar panel or other photovoltaic device and into a rechargable LiPo battery. Set- is easy as well, just plug your solar panel into one side of the Solar charger and your battery into the other and you are good to start charging!
The output of the Solar Charger is intended to charge a single polymer lithium ion cell. The load should be connected in parallel with the battery. By default, the Solar charge comes set to a maximum charge current of 500mA with a maximum recommended input of 6V (minimum 4.4V). It's recommended that batteries not be charged at greater than their capacity rating.

color:
Material: PC + metal
Solar panel input: 4.4-6V
Max charge current: 500mA
Interface: 2-pin JST connectors(or PH2.0)
Short circuit protection
Continuous Charge Current to 500mA
Battery status indication ( Red: Charging , Green: Charged )
Support USB Charge (Micro-USB Connector)
Size:2cm x 4cm

Package Contents:10 x module