2S-3S 5V-16V 8A RC Model Brushless ESC PWM Motor Driver ESC Board DL03 Micro Brushless ESC Controller

2S-3S 5V-16V 8A RC Model Brushless ESC PWM Motor Driver ESC Board DL03 Micro Brushless ESC Controller Περιγραφή

1. Supports 2S-3S batteries with a wide voltage range, suitable for various RC model needs
2. High operational stability ensures efficient and continuous motor operation
3. Supports precise speed control, flexibly adjusting motor speed based control signals
4. Miniature design saves space, suitable for installation in various miniature RC models
5. Smooth low-speed startup reduces startup impact and extends equipment lifespan

Parameter
Output Capacity: Continuous Current 8A (depending actual load power)
Power Input: 12V ( 5-16V/2-3S lithium battery pack)
Control Signal: PWM
Signal Pulse Width: 0.9mS~2mS

Notes:
1. Ensure correct polarity when connecting wires! It is strongly recommended to parallel capacitors and diodes between the positive and negative terminals to protect other components of the ESC!
2. Overloading the ESC may cause overheating protection, resulting in the motor slowing down or stopping, or even burning out!
3. When using a 2S battery, ensure the capacitor is properly connected! Ensure adequate cooling when in use, especially when using 2A to 3A or higher! The ESC has only a signal input pin and does not provide a 5V power supply voltage output. It is driven by a standard PWM signal from a general RC model receiver and can be operated using an ESC tester. The ESC is compatible with small brushless motors such as 1104, 1106, or 1306. Actual use requires testing and verification.
4. The three wires of the brushless ESC can be connected in any order. If the direction is incorrect, simply swap any two wires.
5. General wire colors: red for positive, black for negative, and yellow for signal.
Color:
Material: PCB

Package Contents:
Brushless ESC x1
25V 470uF electrolytic capacitor x1