FOC DC driver board for brushless motors

FOC DC driver board for brushless motors Description

FOC DC Driver Board for Brushless Motors Description
STM32F103VET6 as main control MCU
PWM signal isolation drive, logic chip with short-circuit protection for upper and lower tubes
3-way discrete high- and low-side gate drivers IR2110 and 6 NMOS tubes form BLDC drive circuitry, with Hall encoder isolation circuitry and fast-response hardware overcurrent protection circuitry
Can be used to control the smooth and highly accurate operation of brushless BLDC motors with Hall sensor within 3000 RPM 10 A
Reserve bus voltage isolation detection, thermal protection detection, three-phase counter-electromotive force isolation detection, Three-phase current isolation detection circuit to facilitate secondary development
Uses STM32F103VET6 Arm 32-bit M3 CPU
Uses 3-way IR2110STRPBF gate driver, PWM isolation circuit, short-circuit protection logic circuit, and 6 NMOS tubes to form the BLDC drive section
Supports a 3000 RPM brushless motor and Hall encoder as standard
Supports a maximum load current of 10 A as standard; if 10 A is exceeded, hardware short-circuit protection is automatically triggered
Supply voltage: DC 12-40 V;
Integrated Isolated 5V and 3.3V power output
Color: Black
Material: PCB
Package includes:
1 x Driver board for controlling brushless motors
Only the above package contents, other products are not included.
Note: Light reflections and different displays may cause the color in the picture to differ slightly from the actual product. The allowable measurement error is +/- 1-3 cm.
[OnBuy.com]