L298N Motor Driver Board Module for Robots and Smart Cars

L298N Motor Driver Board Module for Robots and Smart Cars Description

This module uses L298N as the main driver chip, which has the characteristics of strong driving ability, low heat generation and strong anti-interference ability.
The chip adopts 15-pin package. The main features are: high working voltage, up to 46V; large output current, instantaneous current up to 3A, continuous working current of 2A; rated power 25W.
It contains two H-bridge high-voltage and high-current full-bridge drivers, which can be used to drive DC motors and stepper motors, relay coils and other inductive loads, and uses standard logic level signal control; it has two enable control terminals, which allow or prohibit the device from working without being affected by the input signal.
There is a logic power input terminal, which makes the internal logic circuit part work at low voltage; it can be connected to an external detection resistor to feed back the change to the control circuit.
The chip can drive a two-phase stepper motor or a four-phase stepper motor, or two DC motors. The module can use the built-in 78M05 to take power from power supply part, but in order to avoid damage to the voltage regulator chip, when using a drive voltage 12V, please use an external 5V logic power supply. The module uses large-capacity filter capacitors and freewheeling protection diodes to improve reliability.

Main control chip: L298N
Working mode: H-bridge drive (dual-channel)
Logic voltage: 5V-7V
Logic current: 0-36mA
Driving voltage: 5-35V, if power is required from the board, the power supply range is 7V-35V
Driving current: 2A (MAX single bridge)
Storage temperature: -20 to +135
Maximum power: 25W
Control signal input voltage range: Low level: - 0.3VVin1.5V
High level: 2.3VVinsVss
Enable signal input voltage range level: - 0.3Vins1.5 (control signal invalid)
High level: 2.3VVinsVss (control signal valid)
Color: As Shown
Material: PCB

Package Contents:
1 x L298N module
1 x Mini L298N board

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.