1 Pcs TDA8932 Mono 35W Digital Amplifier Module & 1 Pcs Extended NEMA 17 Stepper Motor Cable

Opis produktu: 1 Pcs TDA8932 Mono 35W Digital Amplifier Module & 1 Pcs Extended NEMA 17 Stepper Motor Cable

1 pcs Digital Amplifier Module & 1 pcs Stepper Motor Cable
Sound quality is very good With this module.
Mono digital audio power amplifier chip.High performance and low power consumption.
Applicable speaker impedance: 4/6/8 ohm (8 ohms is the best).
Operating voltage: 10-30V

Power board Amplifier Module:
Recommended use Voltage 24V Output 2A Power supply
Power: 35 W
PCB Board Size: 45 x 31mm / 1.77 x 1.22 In
Color: as shown
Stepper motor link :
Colour:multicolor
Material:ABS
Helpful Support
New stepper motor cable for the most common NEMA 17 steppers found 3D printers.
size:Length 1M
Length is great for swapping to a Bowden (remote) extruder where your existing cable may not be long enough, or when moving your control board to the outside of an enclosure.
This has the standard JST stepper connector with 4 pins wired the stepper end, and a 4-pin 2.54mm dupont connector the controller board end.

Package Contents:
1 x Power board Amplifier Module
1 x Stepper motor link