Fluoride Water Filter K5366 Arsenics Filters Compatible for Gravite Water Filetering System Purification Elements

Fluoride Water Filter K5366 Arsenics Filters Compatible for Gravite Water Filetering System Purification Elements Popis

1. With the caps in place wash the exterior of each fluoride filter Elements with water and mild dishwashing soap, then rinse. With clean hands, remove both caps from each end of both filter Elements.
2. Place the rubber priming button (tan colored) onto one end of a fluoride filter and align the hole of the filter with the hole of the rubber washer. Press the priming button against the sink faucet so that the priming button creates a seal between the faucet and the Fluoride Filter. Place your thumb top of the faucet to apply pressure, to create a better seal (as seen in picture).
3. While holding the priming button against the faucet, turn the cold water slowly, allowing water to fill the cavity of the filter and flow from the opposite end. Allow water to flow for at least 30 seconds or until water runs clear.
4. Turn the Fluoride filter over and prime the opposite end (reversing the flow of water) repeating steps 3-5 until water runs clear from both directions.
5. To determine if the filter is fully primed, collect the filtered water in a clear glass and hold it to the light to see if all of the cloudiness is gone from the water, if not continue priming until water is clear. This filter is now primed and ready to install. Repeat priming steps 1-7 for each additional Fluoride Filter.

[High-efficiency Filtration]: Replacement for PF-2 fluoride filters effectively reduce fluoride and arsenic, absorb odor, color, residual chlorine, heavy metals, they also reduce sediments and large particles effective in improving taste
Colour:White
Material:plastic

Package Contents:
2 x Water Filter
1 x Rubber ring