ATtiny817 Breakout Board Seesaw Development Board - with STEMMA QT Connector

ATtiny817 Breakout Board Seesaw Development Board - with STEMMA QT Connector Kuvaus

The ATtiny817 is part of the 'next gen' of AVR microcontrollers, and now we have a cute development/breakout board for it, with just enough hardware to get the chip and running.
It's also an seesaw board. seesaw is a near-universal converter framework which allows you to add and extend hardware support to any I2C-capable microcontroller or microcomputer. Instead of getting separate I2C GPIO expanders, ADCs, PWM drivers, etc, seesaw can be configured to give a wide range of capabilities.
This board comes pre-programmed with seesaw peripheral code that will let it act as an "I2C to something" converter, basically a little I2C-controlled friend to do all the timing-sensitive things many microcontrollers and microcomputers are not good at.
Finally, with STEMMA QT connectors it, you could use it as either an I2C controller or peripheral with plug-and support.

Specifications:
ATtiny817 8-bit microcontroller
8KB flash, 512 bytes of RAM, 128 bytes of EEPROM
Internal oscillator can run to 20MHz
Internal hardware multiplier
Can run from 2V to 5V power/logic
3.3V regulator - by default we run at the Vin voltage, which can be 5V, but there's a solder jumper the bottom if you'd like to select 3V logic.
Green power LED
Red indicator LED
Two STEMMA QT I2C connectors with 10K pullup resistors, connected to pins 10 and 11
Color: Black
Material: PCB

Package Contents:
1 * Breakout Board