NF-8506 Network Cable Tester Supports Test/IP Scan/Network Port Speed Multifunction Cable Tracker Finding Tool

NF-8506 Network Cable Tester Supports Test/IP Scan/Network Port Speed Multifunction Cable Tracker Finding Tool Kuvaus

Test : Customers were suggested to set IPV4 for the first to use test function, after enter the test function customers can use /Down button to choose "Set IP" to set the local IP, Subnet Mask, and Gateway, after setting these, customers need to save the settings then can return to use the scan functions.
Balayage IP: Using /Down button to choose "Set IP" to set the local IP, Subnet Mask, and Gateway, after setting these, customers need to save the settings then can return to use the IP scan functions.
Test de commutateur: After testing, the testing result will show the standard of the (10M/100M/1000M) and also the duplex mode of the .
PS: After testing, customers need to reprocess the whole steps for new port testing to ensure the accuracy of the testing. Reglages: Customers can set language, backlight level, backlight , auto default setting, about etc.
Digital Mode: Anti-interference, when tracking cables with load from 1000M switches, customers were suggested use this mode. Analog Mode: With little noise, customers were suggested to use this mode when tracking cables without load. Transmitter: Default set to Digital mode, use /Down button to between the two modes.

1. Cable Continuity Test
2. Modes: Remote and .
3. Remote: Can test cable continuity, /Short Condition.
4. : Can only test cable continuity.
5. Receiver: If the scan signal indicator stays , it means the receiver is in Digital mode; If the scan signal indicator blinks, it means the receiver is in Analog mode.
6. Two Modes: Digital Mode/Analog Mode, Customers can use /Down to .
Model:NF-8506
Cable Scan:Digital Mode/Analog Mode
Transmitter:
1. Cable Continuity Test:Remote &
2. Cable Length Test:Range:5-200m()
3. Port Flash:10M/100M/1