Εικόνες προϊόντος
For EMID & Card Dual Frequency Access Control Card Reader,Wiegand26/34,UART TTL RFID Card Reader, NFC Card Reader
Νέο
Σε απόθεμα
Γιατί θα λατρέψεις τις αγορές στην OnBuy :
- Κέρδισε Επιστροφή Ποσού σε κάθε αγορά – ξόδεψε το άμεσα στην επόμενη παραγγελία σου
- Δωρεάν παράδοση – σε εκατομμύρια προϊόντα σε όλο το site
- Οι πελάτες μας λατρεύουν – 128,000 κριτικές με βαθμολογία « Άριστα »
29,86 €
+8,08 € Παράδοση
1%
Τι είναι το άμεσο Cashback;
Μάθετε περισσότερα
Οι τιμές για τα είδη που πωλούνται από την OnBuy περιλαμβάνουν ΦΠΑ.
Διαθέσιμες άτοκες επιλογές πληρωμής
Δες την πλήρη περιγραφή & λεπτομέρειες του προϊόντος
Παράδοση: Κανονικό (8,08 €) | Δευ 20 - Σαβ 25 Ιουλ
Επιστροφές: 30 ημέρες
Προστασία πληρωμής 180 ημερών
Περιγραφή & Λεπτομέρειες
Περίληψη
- Product Name: Dual-frequency access control reader; Operating Frequency: 125Khz , 13.56Mhz; Sensing distance: 0-15CM; Operating voltage: DC5-16V; Operating Current: Static Less than 30mA;Dynamic Less than 40mA; Communication format: Wiegand26/34, UART TTL; Working humidity: 10%~90%; Baud rate: 9600.N.8.1; Working temperature: -30℃~85℃; Ways of identifying: Swipe card
- Card reading types: IC card, supports S50, S70 and their compatible cards, M1 card, ID card, EM4100 card etc.(does not support HID, Cobra, APCiK, etc.)IC card, supports S50, S70 and their compatible cards, M1 card, ID card, EM4100 card etc.(does not support HID, Cobra, APCiK, etc.)
- Installation precautions: The line from the card reader to the controller: It is recommended to use an 8-core shielded multi-strand twisted pair network cable (two of which are spare, if the card reader light feedback legal card is not required, the LED cable can not be connected, if the buzzer of the card reader is not used) The Buzzer line can not be connected to the illegal card feedback from the device), and the data lines Data1 and Data0 are a pair of twisted pairs.
- UART TTL RFID Card Reader
- Doorbell NFC Card Reader
For EMID & Card Dual Frequency Access Control Card Reader,Wiegand26/34,UART TTL RFID Card Reader, NFC Card Reader Περιγραφή
Product Name: Dual-frequency access control reader; Operating Frequency: 125Khz , 13.56Mhz; Sensing distance: 0-15CM; Operating voltage: DC5-16V; Operating Current: Static Less than 30mA;Dynamic Less than 40mA; Communication format: Wiegand26/34, UART TTL; Working humidity: 10%~90%; Baud rate: 9600.N.8.1; Working temperature: -30~85; Ways of identifying: Swipe card
Card reading types: IC card, supports S50, S70 and their compatible cards, M1 card, ID card, EM4100 card etc.(does not support HID, , APCiK, etc.)IC card, supports S50, S70 and their compatible cards, M1 card, ID card, EM4100 card etc.(does not support HID, , APCiK, etc.)
Installation precautions: The from the card reader to the controller: It is recommended to use an 8-core shielded multi-strand twisted pair network cable (two of which are spare, if the card reader light feedback legal card is not required, the LED cable can not be connected, if the buzzer of the card reader is not used) The Buzzer can not be connected to the illegal card feedback from the device), and the data lines Data1 and Data0 are a pair of twisted pairs.
The wire diameter is recommended to be more than 0.3 square millimeters. The longest can not exceed 100 meters. The shield wire is connected to the GND of the controller.
The card reader is installed a metal surface. Since the card reader is a radio frequency product, the metal pair near the front or the rear will absorb its radio frequency signal. If the metal surface is large, it will even affect the card reader. card, or the reading distance is very attenuated.
The distance between the two card readers will also affect the card reader, some will shorten the card reading distance, and some will cause the two card readers to read the card at the same or the card reader cannot read the card.
Solution: Try not to insta
Λεπτομέρειες
| OPC | PWDTD7K |
|---|---|
| Κωδικοί | 6032660808119 (EAN) |
| Πληροφορίες προϊόντος και ασφάλειας |
Στοιχεία Προϊόντος
| Height | 2cm |
|---|---|
| Width | 5cm |
| Length | 5cm |
| Weight | 0.0225kg |
| Colour | As Shown |
| Material | Plastic |
Σύγκρινε Πωλητές για For EMID & Card Dual Frequency Access Control Card Reader,Wiegand26/34,UART TTL RFID Card Reader, NFC Card Reader
- Νέο από 37,94 €
| Πωλητής | Αξιολογήσεις | Εγγύηση | Επιστροφές | Τιμή | Παράδοση | Σύνολο | Ποσότητα |
|---|---|---|---|---|---|---|---|
|
Αποστολή από:
|
(62 αξιολογήσεις) | - |
30 ημέρες
Δωρεάν επιστροφές Όχι
|
29,86 €
|
+8,08 € Delivery
Εκτ. Παράδοση:
20-25 Ιουλ
|
37,94 €
|
Κέρδισε καθώς ψωνίζεις με άμεσο Cashback σε όλα.
Χωρίς παγίδες, χωρίς κόστος
- Καταβάλλεται στον λογαριασμό σας στο OnBuy
- Ξόδεψέ το στην επόμενη αγορά σου
- Αποθήκευσέ τα ή κάνε ανάληψη
Γίνετε Cashback VIP
Μόνο 1 αγορά ξεκλειδώνει μεγαλύτερες προσφορές και καλύτερα ποσοστά