PWM Motor Speed Controller 10 -55V Digital LED Display 0 - Adjustable Drive Module Input 40A 12V 24V 36V 48V

PWM Motor Speed Controller 10 -55V Digital LED Display 0 - Adjustable Drive Module Input 40A 12V 24V 36V 48V leírása

With forward and reverse , potentiometer knob with , forward and reverse can be controlled by PLC. The forward and reverse can be replaced with a jog .
The display tube and the module are connected by a cable. The cable may loosen and fall off during express delivery. Buyers need to insert it tightly by themselves. If you mind, don't take pictures.
With 0-100 percent digital scale positioning.
Make sure that the positive and negative connections are correct before powering , and the wiring should not touch the heat sink, which may burn the circuit board. Note that this is not a power module, and the motor must be connected to adjust the speed. If the motor is not connected, the output of the multimeter will not change, and it cannot be connected to AC. For brushed motors.

Input voltage: 10-55V (equal to the rated voltage of the motor)
Output voltage: linear under load
Maximum current: 60A
Continuous current: 40A
Speed regulation type: current regulation
Speed regulation mode: potentiometer (linear)
Support motor: brush motor
Forward rotation reverse: Support
Speed range: 0 -
Control frequency: 15KHz
Wiring type: terminal Knob
Specification: 100K (with )
Wiring type: fence terminal block
Product weight: 170g
Note:
Electric bicycles cannot be used, including electric bicycle motors.
The input voltage must be divided into positive and negative can not input 220V household electricity.
The input voltage should be equal to the rated voltage of the motor (within 10-55V).
The digital display is the motor full speed percentage 0-100, not the actual speed of the motor.
The input voltage must be divided into positive and negative.
The input voltage should be equal to the rated voltage of the motor within 10-55V