Automatic Foot Pedal Sensor for Car Trunk Electric Tailgate Kick Electric Induction Tailgate Trunk Opening Sensor

Automatic Foot Pedal Sensor for Car Trunk Electric Tailgate Kick Electric Induction Tailgate Trunk Opening Sensor Beskrivelse

At present, most car trunks the market need to be opened by a key or a manual button.When the owner holds a large item in the trunk, he must place the item the ground and then open the trunk by hand, which is inconvenient to operate.
This product solves the above problems, and is installed inside the rear tailgate of the car, and emits microwaves downward for detection.If the sensor detects an effective kick in the sensing area, it outputs a corresponding level signal according to the signal strength. Control the opening of the tail box.
Normal mode: approach the foot of the bumper sensing area and then leave the bumper sensing area. When this action is completed, a trigger signal will be generated.
Abnormal patterns: stairs, stones, branches, rough roads, plastic bottles, car wash, etc., no trigger signal is generated
The thread color is random and cannot be specified.

Colour:Black
Material:plastic

Package Contents:
1set * kick boot sensor
Installation Notes:
1. Find the proper position the rear guard of the vehicle.
2. Wipe the installation position of the sensor.
3. Peel off the double-sided tape of the sensor (the side of the double-sided tape is the detection surface) facing the ground
4. Connect the sensor firmly to the rear protective plate (inside of the bumper)! The sensing surface should avoid metal objects such as iron and aluminum.
Second, after power- test, wait for 20 seconds after power-.After the product self-test is completed, you can do kicking or sweeping movements under the sensor.
1. The sensor can only recognize one action, either kick once or sweep once
2, After each action is completed, you need to wait 2 seconds before continuing the operation
Third, the product's working characteristics, one kick cannot be used after the car is started, and one kick is used normally after the flame is turned off.

Only the above package co