DIY Digital Oscilloscope Electronic Kit 5V STC Microcontroller Electronic DIY Loose Parts with 0.96 Inch DOS LCD

DIY Digital Oscilloscope Electronic Kit 5V STC Microcontroller Electronic DIY Loose Parts with 0.96 Inch DOS LCD Beskrivelse

Indicator light: usually the indicator light indicates that the sampling is running. There are three trigger modes: automatic mode, normal mode and single mode.
Trigger slope: the trigger slope determines whether the trigger point is the rising of the signal or the falling .
Trigger level: For repeated signals, the trigger level can stabilize the display. For single signal, the trigger level can be captured
Save Settings: When you exit the setup interface, all the parameters of the setup interface and the main interface will be saved in EEPROM.
Waveform generator: PWM (PWM generator) and SIN (sine wave generator), adjust RP1 and RP2 to change the amplitude respectively.

Parameter:
Supply voltage: 5V (micro usb)
Voltage range: 0~30V (LSB adjustment required)
Level sampling: 10kHz@100us/div
Sec/div: 500ms, 200ms, 100ms, 50ms, 20ms,
10ms, 5ms, 2ms, 1ms, 500us, 200us, 100us
Board size: 57*35mm
Finished size: 57*35*30mm
Color:
Material: plastic

Package Contents:
1 set Oscilloscope Electronic Kit