4x for H3 2006-2010 Car Front Hood Engine Cover Support Rod Shock Spring Strut Bonnet Lifting Bracket

Descriere 4x for H3 2006-2010 Car Front Hood Engine Cover Support Rod Shock Spring Strut Bonnet Lifting Bracket

compression gas springs type, also known as free type gas spring, supporting bar, nitrogen spring is a high-pressure gas sealed in the cylinder, the piston produced by the elastic features of the product. The product does not need to work at the outside power, constant lifting force. Fully open the rear door is widely used in automobile, hood, back door luggage, mechanical equipment, construction machinery, furniture, fitness equipment, and other fields.
It has a long life, easy to control, no maintenance and so .
High quality and long service life.
Easy to install.
Suitable for For 2006-2010 H3

Instructions:
1. Use Safety stands whenever a procedure requires you under the vehicle or supports. Or have someone hold the lid open for you so that they can raise or lower it as needed.
2. Before removing the old lift support, inspect the end connections and compare them to the units your vehicle to make sure that they are the same As well as the extended length.
3. Remove the old support from the vehicle by placing a small flat headed screw driver under the U shaped band the ends of the support. Slowly turn the screw driver and it will lift the band approx.1/8 inch, then pull the support away from the vehicle and it will release.
4. To install the new supports do the same procedure in reverse. DO NOT jam the new support end over the socket without lifting the U band slightly or damage may occur.
5. Lift Supports need to be installed fully extended. In most cases you just can't compress them unless they are the vehicle.
6. If the ends are not lining the support may need to be turned. To do this attach the shaft end of the support to the vehicle and then turn the entire body of the support clockwise unit the ends .
Colour:black
Material:metal
Size:
Compresse