Dual Motor Driver Module Board H-Bridge MOSFET IRF3205 3-36V 10A Peak30A

Dual Motor Driver Module Board H-Bridge MOSFET IRF3205 3-36V 10A Peak30A Popis

You can compare the driving performance of these non-L298 motor driver chips.
These drivers focus current and efficiency, which can effectively improve motor power and battery life.
Can withstand high current overload, the maximum current can reach 30A
This driver also has a braking function, which can quickly stop the motor, the braking is fast, the braking effect is obvious, and it is easy to implement this function
This driver uses a complete two-half-bridge driver chip + low-resistance N-channel MOSFET components.

Parking brake: DIR = X PWM = 0 (X is any state)
Motor forward: DIR = 1 PWM = PWM
The reliable driving mode of the full two-half-bridge driver chip is adopted to minimize the switching loss of the MOSFET. Improve power utilization.
The MOSFET driver chip comes with hardware braking function and power feedback.
This driver chip is an excellent integrated low-power solution that can be coordinated with other complex problems in half-bridge power margin solutions and supplement the driving problem. N-channel MOSFET uses IRF3205 MOSFET, uses two dedicated half-bridge driver chips, and uses boost capacitors the top of the tube, so that the MOSFET channel with sufficient drive voltage the tube can be quickly opened, increasing the motor acceleration curvature, and can also quickly brake the motor. This allows the car to start quickly and also quickly shut down. The driver can operate at a duty cycle of 0-99%, and sufficient motor drive voltage can be obtained through PWM modulation. Motor reversal: DIR = 0 PWM = PWM POWER connects to the positive pole of the power supply, and GND connects to the negative pole of the power supply. Connect two motors MOTOR1 and MOTOR2 Motor and power connection Rated current: 10A Rated voltage: 3V-36V current: 30A
Color: Green & Black
Material: PCB