CM4 WiFi7 Expansion Board for Raspberry Pi Computers Module Support WiFi 6/WiFi 5 with Aluminum Alloy Casing +Antenna

CM4 WiFi7 Expansion Board for Raspberry Pi Computers Module Support WiFi 6/WiFi 5 with Aluminum Alloy Casing +Antenna Kuvaus

Onboard USB (BE200 module has built-in function)
Short the Boot and OTG jumpers, then power the device. Connect the USB-C port in the upper right corner to enter the programming mode (remove the two shorting caps after programming is complete)
Shorting the OTG jumper alone allows the USB-C port in the upper right corner to be connected to a PC for Device applications after the system boots (used to simulate the board as a USB flash drive, network card, HID keyboard and mouse; firmware support required)
If the OTG jumper is left floating, the USB signal will connect to and the three USB-A host

Note that a USB-C device and a USB-A host cannot be used simultaneously!
Supports the entire series of RPi CM4 core boards
(The product printed words may vary depending the batch, but this does not affect use)
Color: As Shown
Material: Pcb+Aluminum Alloy

Package Contents:
1*Expansion Board kits(Screw color and style are random)