3000W Instant Electric Water Heater UK Plug

3000W Instant Electric Water Heater UK Plug Description

Item Type: Electric Water Heater Voltage: UK Plug220V Power: 3000W Heater Body: Stainless Steel Frequency: 50-60Hz Wire: 1.5mm² Temperature Range: 20-50 Material: ABS, Copper, Stainless Steel Weight: Approx. 1094g / 38.6oz Installation Requirements: For kitchen, toilet, bathroom, shower room, electric wire shall be more than2.5mm²; The circuit breaker switch is greater than32A Common Faults and Solutions: 1. Check whether the power supply is normally powered on. The indicator light on the power on display will show the temperature, but it will not light up if it is not powered on. 2. Under normal power on condition, the water flow is turned on, press the key, the machine starts heating, and the water heater displays the outlet water temperature. 3. If the temperature does not rise, there are2possibilities: one is that the temperature control switch (overheat protection switch) inside the water heater jumps and can be recovered by pressing the temperature control switch; the other is that the heating pipe is faulty and can be replaced. 4. If the display shows no heating, and the display shows that the marquee lamp turns around, it means that the water flow has not passed through the water heater, or the water pressure is too low, or the installation direction is wrong. Please note that the water inlet and outlet should be installed correctly, but if the water pressure is enough, and the water flow does not heat, then check the water inlet worm wheel of the water heater. It may be that there is something dirty that is stuck in the worm wheel, causing the water heater to not start. 5. The length of the water outlet pipe of the water heater is recommended not to exceed3meters. If the length of the water outlet pipe exceeds3meters, the water pressure difference may occur due to the length of the water pipe. If the water pressure is not enough, the water can not be started (If the water tower is used in rural areas, the height of the water tower is required to be higher than10m to make the water pressure reach the starting value). 6. The display screen shows E1overtemperature, E3E4or temperature sensor failure. First cut off the power, pass the machine through with cold water, and then use it after powering on. Pay attention to the use of water flow not too small at ordinary times. 7. The heating tube fault displays E2, and the heating tube needs to be replaced. .wang-edit-text{ font-family: 'Arial' !important; } .wang-edit-text table { border-top: 1px solid #000; border-left: 1px solid #000; } .wang-edit-text table td, .wang-edit-text table th { border-bottom: 1px solid #000; border-right: 1px solid #000; padding: 3px5px; } .wang-edit-text table th { text-align: center; }