300W DIY Soldering Temperature Blower tool Electric Power Hot EU Plug

300W DIY Soldering Temperature Blower tool Electric Power Hot EU Plug Description

uses high-quality motors, operates efficiently, is powerful and .
Multi-level temperature adjustment is suitable for work requirements.
is used in electronic electricians, product packaging heat shrink film, car bumper repair, paint removal, drying and thawing to replace floor tiles, bending plastic tubes, blowing heat shrink tubes, refrigerator defrosting, clothing factory thread ends, etc.
1.06 shell adopts PP+GF30 color matching design.

Working environment temperature -10-40
Rated input voltage AC220V, AC110V
Rated frequency 50Hz, 60Hz
Maximum power consumption 300W
Use power range 150W-300w
Standby power consumption less than equal2W
Air volume 200-450 liters/minute
Output temperature 230-380, maximum air outlet temperature 330-350 (actual measurement point is away from the air outlet).
The lowest temperature at the air outlet is 230-280 (the actual measurement point is away from the air outlet).
Noise less than equal76 (at 30cm from the air outlet)
Start switch and temperature adjustment
1. Start the switch
Use the gear switch on the handle to select the switch and gear. The "O" position shuts down the machine; the "I" has low temperature and low wind speed and cannot be adjusted; the "II" second gear has high temperature and high wind speed and cannot be adjusted.
2. Two temperature settings, one is half open and the second is fully open.
Plug Type: EU Plug,it applies to Indonesia, Germany, France, Spain, Italy and so on.
Voltage: AC220V
Colour:Photo Color
Material:Plastic

Package Contents:
1x Heat Air tool set

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.