Solar Charge Controller PWM 10A 12V/24V

Solar Charge Controller PWM 10A 12V/24V Description

Specification: material: plastic System voltage: 6V, 12V Output current: 10A, 3A Power range: 60W(6V), 120W(12V) Overload and short circuit protection: yes No-load loss: 5mA Voltage drop of charging circuit: 0.2V Discharge circuit voltage drop: 0.1V Protection class: IP30 Working temperature: -40~55 Installation and usage: First determine the output mode of the controller, the factory default setting of the device is normally open mode. If you need to set it to pure light control mode or light control plus timing mode, you need to open the shell by setting the DIP switch to change the discharge mode When the button "on" is 1, the button "off" is 0, normally open, pure light control Connect the battery first. If the connection is correct, the battery light will be on Connect the wires to the solar panel. If connected correctly, the Charge light will turn on or flash 10 seconds after being outdoors in the sun. Otherwise, check the connection Make sure the solar panels are placed outside in sunlight Connect the load. If reversed, the LED light may be damaged Please pay attention to the anode and cathode to avoid reverse connection The package contains: 1* Automatic solar charge controller