Universal remote control copy for garage door 433 MHz

Universal remote control copy for garage door 433 MHz Description

Code cloner for an extra spare remote control: RF code cloner in remote control design to clone over your old remote control codes. Perfect for transferring/copying the code for garage doors, automatic gates, security systems and home appliances.

Always a backup close at hand: Duplicate the functions of your original remote control with this 4-channel RF duplicator with learning functions, so you always have a backup or spare garage door opener on hand.

Perfect for the garage door: Compatible with fixed frequency of 433 MHz, which is the frequency used by the vast majority of garage door openers.

Compatible with the following chipsets: 2260 (all manufacturers) 2262 (all manufacturers) PT2264, 5326 (all manufacturers) SC5262, HT600, HT680, HT6207, HT6010, HT6012, HT6014, SMC918 series, 527 (all manufacturers) 1527 (all manufacturers) 2240 (all manufacturers) HCS101, HCS200 \ HCS201 (parts of code) HCS300 \ HCS301 (parts of code) Parts of single chip.

NOTE: This model is not suitable for rolling code. In that case, you should have another model. Cannot copy the car's alarm box (for security reasons).

Specification:

Signal transmission speed: 50-60 KHz
Voltage: 12 V
Current strength: 10 mA
Frequency: 433 MHz
Power signal transmission: 10-12 mW
Distance signal transmission: Up to 50 m with free surface
Color: Black/silver
Battery: 2V27A battery (included)
Size: 6x4x1.2cm
Weight: 28 g

The package includes:

1 x Universal Code Cloner - Remote Control

How to copy:

Step 1: Remove the old code from the duplicator

1. Press buttons A and B continuously until the LED flashes

2. Release button B (keep pressing button A) and slowly press button B 3 times, LED flashes

3. Release button A, the code removal is complete

Step 2: Copy code from original transmitter

1. Place the duplicator as close to the original transmitter as possible.

2. Press and hold button A on the original transmitter, press and hold button A on the duplicator, until you see the duplicator's LED flash.

3. Release both buttons, finish code copying. Copy the next button in the same way.

Recovery function:

Press and hold buttons C and D for 3 seconds, LED flashes, all buttons go back to the last copied codes.