3/8" 175~185 Electric Engine Fan Thermostat Temperature Relay Switch Sensor Kit

3/8" 175~185 Electric Engine Fan Thermostat Temperature Relay Switch Sensor Kit Description

Specifications: 

Voltage: 12V

Material: plastic and metal 

Comes on at 185o AND Turns off at 175o

Wire length: approx. 0.9m Wire 1.5 square, colour as shown

Quantity: one set 0.25KG

Suitability: 

Suitable for 265 283 305 307 327 350 383 400 396 402 427 454 472 502 260 289 302 351W 347 352 360 390 Engine 

Suitable for 406 427 428 429 460 351C 351M 400M 273 318 340 360 361 383 400 413 426W 440 455 330 326 engines 

Installation instructions: 

NOTE: Install the relay under the bonnet to allow for the fan. 

CAUTION: Do not use teflon tape or string connections on the thermostat or adapter. For proper operation, the thermostat must be grounded to the engine with the threads grounded to the engine. 

2. Install the thermostat into the head or intake manifold. Connect the black wire to the thermostat, cut to length. Press the red terminal onto the black wire and connect to the thermostat. 

3. Connect the red wire to the fan + terminal or power cord from the print to the motor of the electric fan. 

4. Install the circuit breaker in a convenient location as close as possible to the power source used for the fan relay (battery or large terminal on the starter appliance). 

5. Use the small yellow ring end to cut the length and install. Using the other small yellow ring terminal, the remaining red wire can be connected and the unused post on the circuit breaker can be connected to the battery source. 

This wire is printed on the battery / standing heat. 

6. Connect the brown cable to the ignition switch or fan switch, whichever is more convenient. 

Notes: 

Manual measurements are subject to a 0.1-0.5cm error.

Not includes the FAN.

Package includes:

1 Set* temperature sensor switch kit