433mhz Garage Door Remote Control Key Replacement 4 Buttons Cloning Copy Cloner Universal

433mhz Garage Door Remote Control Key Replacement 4 Buttons Cloning Copy Cloner Universal Description

433mhz Garage Door Remote Control Key Replacement 4 Buttons Cloning Copy Cloner Universal
Item Type: Garage Remote Controller
Material: Metal + ABS
Battery Type: Button Battery (included)
Battery Capacity: 120mAh
Battery Model: CR2025
Colour: Black
Working Voltage: DC6V
Rated Current: 0.5mA
Working Frequency: 433MHz
Buttons: 4 Buttons (A B C D)
Code Pairing Format: Face-to-face (one-to-one)
Modulation System: AsK (AM)
Transmitting Power: +13dbm
Wind Frequency: 0.2MHz
Transmission Distance: Approx. 30m-100m/98.4-328.1ft
Instruction:
1. The chip can be copied
2260 (all manufacturers); 2262 (all manufacturers); PT2264, 5326 (all manufacturers); SC5262, HT600, HT680, HT6207, HT6010, HT6012, HT6014, SMC918 series, 527 manufacturers (2715all) all manufacturers); HCS101, HCS200 / HCS201 (Part Code), HCS300 / HCS301, MCU part...
2. How to clean the code:
Press the unlock button and the lock button at the same time (in some cases, the button and the button are below). After the LED indicator flashes three times, release any button while holding down the other button, and then press the release button three times. Enter the fast flashing state. At this time, all the memory data are cleared, no matter you press the button, the cleaning remote control will not have the LED light on
3. Copy method
Hold the original remote control in one hand and the copy remote control in the other hand. The two remote controls should be as close as possible (preferably put the two remote controls on the desktop at 0 distance), and press the copy button respectively, when the LED indicator light When it flashes quickly after three flashes, the copy is successful, and the other key operations are the same. Some remote controllers have low transmit power, so the original remote controller must be put back on the duplicate remote controller to operate. In order to avoid the existence of noise, interference should be avoided during operation. If the copy is not correct, copy after clearing the code.