A3 ProV2 6 Axis RC Flight Controller with Precision Gyro Stabilizer for Fixed Wing Airplanes

A3 ProV2 6 Axis RC Flight Controller with Precision Gyro Stabilizer for Fixed Wing Airplanes Description

A3 ProV2 6Axis RC Flight Controller and Stabilizer for FixedWing Aircraft Overview The A3 ProV2 is a compact 6axis gyro and stabilizer designed for fixedwing RC airplanes and DIY drones. Built around a 32bit processor and a precision MEMS 6axis sensor, it delivers stable, reliable control across multiple airframe types and receiver protocols. Its flexible inputs and remote master gain control make installation and tuning efficient for hobbyists and advanced modelers. Key benefits Improved flight stability and smoother handling thanks to a precision 6axis MEMS sensor and advanced control firmware. Easy receiver integration with multiprotocol serial receiver support, reducing wiring complexity and enabling digital receiver use. Flexible tuning options including independent axis sensitivity adjustments and remote total gain control to adapt to different aircraft and pilot preferences. Compact, lightweight design that fits common fixedwing installations without adding significant weight. Main features Processor and sensors: 32bit microcontroller with precision MEMS 6axis sensor for responsive, lowlatency stabilization. Flight modes: Six selectable modes: gyroscope off, normal stabilization, attitude lock, angle mode, automatic balance, and automatic hoist mode. Airframe support and mixing: Configurable for conventional fixed wing, delta wing flying wing, and Vtail mixed control with aileron mixing. Independent sensitivity adjustment for aileron, elevator, and rudder axes. Remote master gain: Adjust total gain remotely from the transmitter for inflight tuning. Firmware upgradeable: Firmware updates supported with a special data cable, sold separately. Receiver compatibility: Supports a broad range of serial and satellite receiver protocols for digital integration: PPM serial receiver Futabacompatible S.Bus FrSkycompatible SBUS WFLY WBUS Spektrumcompatible DSM and DSMX 1024 and 2048 SRXL protocols Multiplex SRXL and JR XBUS Mode B Graupner SUMD FlySkycompatible iBus PWM output: 920 microseconds to 2120 microseconds, center 1520 microseconds, frequency 50 Hz to 333 Hz. Electrical and environmental: Operating voltage 4.8 V to 8.4 V, operating temperature range 10 C to 50 C. Physical: Dimensions 43 x 27 x 14 mm, weight 10 g (excluding connecting wires). Technical specifications Main controller: 32bit microprocessor Sensor: MEMS 6axis precision sensor Gyro range: plus/minus 2000 degrees per second Acceleration range: plus/minus 4 g PWM output range: 920uS to 2120uS, center 1520uS, frequency 50Hz to 333Hz Working voltage: 4.8V to 8.4V Temperature: 10 C to 50 C Size: 43 x 27 x 14 mm Weight: 10 g (excluding wires) Typical use scenarios Trainer and sport planes: Add reliable stabilization to a trainer or sport fixedwing model to reduce pilot workload during takeoff and landing, or to recover from wind gusts. Flying wing or delta conversions: Configure delta wing or flying wing control mixing and tune axis sensitivity for stable cruising and precise aerobatics. Upgrading older models to digital receivers: legacy control hardware with a modern controller that supports multiple serial receiver protocols and remote gain adjustment. What you get One A3 ProV2 RC flight controller unit sized 43 x 27 x 14 mm. Data cable for firmware updates is not included and must be purchased separately. This controller is intended for fixedwing RC use and DIY model installations. Follow safe installation and setup procedures, and verify receiver compatibility before connecting.