Air Compressor Pressure Switch 95125 PSI with Unloader Valve, 4 Port Automatic Pressure Control

Air Compressor Pressure Switch 95125 PSI with Unloader Valve, 4 Port Automatic Pressure Control Description

Pressure Control Switch Valve for Air Compressor 95125 4Port with Unloader What it does Controls compressor cutin and cutout pressures in the 95 to 125 psi range to maintain consistent tank pressure and automatic cycling. Integrated unloader valve releases trapped air at shutdown to reduce motor load and allow easier restarts. Key benefits Reliable pressure management: Keeps pressure between 95 and 125 psi for consistent tool performance and steady output. Reduced restart load: Unloader function vents pump discharge at stop so the motor and pump restart under less stress. Flexible plumbing options: Fourport design supports multiple connections for pump, tank, gauge, and auxiliary fittings. Direct replacement: Designed for compressors that use a 95125 4port pressure switch with unloader, making swapouts straightforward. Durable everyday operation: Built to handle routine cycling in garage,, and light industrial environments. Important attributes Function: Pressure control switch with integrated unloader valve for automatic on off operation. Compatibility: Intended for compressors specifying a 95125 psi pressure switch with a 4port configuration and unloader. Check existing switch model and port layout for fit. Ports: Four ports for flexible connection options to pump, tank, gauge, and accessories. Performance: Provides stable switching between set points and consistent pressure regulation during repeated cycles. Installation: Wiring and mounting match common 4port pressure switch layouts for straightforward installation or replacement. Practical use scenarios Home garage setup: a worn pressure switch on a portable compressor used for inflating tires and operating pneumatic hand tools. Small: Maintain steady pressure for impact wrenches and air ratchets while benefiting from easier restarts after frequent stops. Workshop spray painting or sanding: Keep pressure within specified limits for consistent finish quality and reliable tool operation. What to check before Confirm the required cutin and cutout pressures are 95 and 125 psi for compatibility. Verify the target compressor uses a 4port switch with an unloader and that the physical mounting and electrical terminals match. If uncertain, compare the existing switch label or configuration to ensure a correct replacement. This pressure control switch valve offers a practical replacement solution for compressors needing a 95125 4port switch with unloader, delivering dependable pressure control and simpler restarts without unnecessary complexity.