(Black) Pair Of Meter Box Covers - Black or White

The Overbox dimensions are as follows:-

634mm height x 494mm width x 100mm depth.

Internal dimensions are 616mm height x 440mm width x 66mm depth.

Advantages of The Overbox,

o  Moulded in ASA engineering material compared to competitor products moulded in GRP material or Aluminium.

o  High impact ASA engineering material is more resistant to; damage during transit, installation and damage from vandals compared to GRP materials used on conventional Meter Box Housings.

o  ASA Material is UV Stable with excellent resistance to weathering and colour discolouration. Developed specifically to meet the replacement repair needs of the smart meter roll out for gas and electric installations for inset meter boxes, whose dimensions are no bigger than 618mm height x 440mm width x 66mm depth.

o  ASA polymers provide long service life and are currently used in these products for outdoor applications: Water and Rainwater Fittings, Car Roof Boxes, Boat Hulls and Automotive and Garden Products.

o  Unlike GRP ASA polymers are recyclable at end of life and can be reprocessed for further use as a moulding material.

o  Manufactured by injection moulding process rather than by compression or resin transfer moulding as standard practice for GRP. In comparison the injection moulded process advantages; reduced cycle time, economical production with minimal waste and a low energy manufacture.

o  ASA Material is 26% lighter than GRP.

o  ASA Material has 33% more impact strength than GRP.

o  ASA moulded products are friendly to handle rather than GRP products containing short chopped strands of glass.

o  Does not dent compared to aluminum

o  Does not chip or scratch like powder coated aluminum boxes

o  Does not corrode in coastal areas like aluminum.

o  Much more cost effective than aluminum boxes

o  Robust assembly and door construction. Door hinge mechanism allows door to be mounted for left hand or right hand opening and is easily replaced in the event of failure. Badge moulding with ‘E' & ‘G' used to identify utility covered for Electric or Gas meter box.

o  The Overbox is designed to fit over damaged inset meter boxes within the sizes above which are designed in accordance with BS8499: 2009. British Standard for Domestic Gas Meter Boxes.

o  The Overbox has a clean modern appearance to blend with all architectural styles.

Fitting:-

The overall box will fit over an inset meter box who's dimensions are not bigger that 618mm height x 440mm width x 66mm depth

Place the Overbox over the inset meter box & position.

With a pencil mark positions where you are going to fix the Overbox to the wall.

Remove Overbox & drill holes into the wall, use a fastening/raw plug suitable for your type of wall construction 

Place the Overbox and fasten screws.

Tighten screws once Overbox is aligned.