Bond It Cyanoacrylate Superglue - Med Viscosity - Clear 20g

Bond It Cyanoacrylate Superglue - Med Viscosity - Clear 20g Description

A high viscosity ethyl cyanoacrylate adhesive with gap filling properties.

HVC16 combines high tensile strength with improved impact resistance resulting in a toughened bond. HVC16 higher viscosity enables it to be used on porous and vertical surfaces without excessive penetration or running.

Uses 

The high viscosity is particularly suitable for use with foam products. 

Bond It HVC16 SUPERGLUE can be used for bonding: 

• PVCu trims. 
• Rubbers. 
• Timbers. 
• Many plastics. 
• Preparation 

Surfaces to be bonded must be clean, dry and free from dust, grease, oil or any other contaminants that may hinder adhesion. 

Application 

HVC16 permits readjustment of components before bonding commences. Apply a thin film to one side only and bring together immediately. Reposition within 2-3 seconds. Maintain light pressure without movement of joint for at least 10 seconds, do not handle until bonding time stated above has expired. Clamp or hold for a few seconds. As the polymerisation of cyanoacrylates is initiated by moisture from the atmosphere best results will be obtained if the relative humidity is in excess of 50%. Higher levels of humidity reduce the opportunity for monomer evaporation thus limiting fume build up. If bonding is continuous process good ventilation must be ensured. 

Limitations 

Not suitable for permanent glass bonding. Oily or greasy surfaces cannot be bonded. Olefinic or fluro polymers may require specialised bonding techniques.

Container Size 20g plastic bottles.