DC10‑60V 2-Channel PWM Fan Speed Controller, 65x65mm, Temperature Measurement

DC10‑60V 2-Channel PWM Fan Speed Controller, 65x65mm, Temperature Measurement Description

DC10‑60V 2 Channel 4 Wire Fan PWM Temperature Speed Controller Governor Module Internal Fans Components
Item Type: PWM Fan Speed Temperature Controller
Material: PCB
Working Voltage: DC10-60V (must be equal to the fan voltage, if you use a 12V fan but supply 24V, it will burn the fan)
Working Current: Control board working current 35mA (12V) 22mA (24V)
Control Ability: Not limited by the fan current, but the pin current of the fan interface on the board should not be greater than 3A current. When using a fan with a higher current, please connect the fan power cable directly to the main power supply!
Control Output Range: 10%-100% (this is only the signal output range, the actual situation depends on the fan performance)
Temperature Probe: NTC 10K B=3950
Temperature Measurement: -9.9C-99.9C, error 2C (1% probe within 70C) 3C (above 70C)
Temperature Control Temperature Zone Range: Acceleration temperature 5-94, full speed temperature 10-99
Speed Measurement: 10-9990 rpm, if the speed is greater than this, it will always display 999, the resolution is 10 rpm, and the display unit is 10 rpm (the speed measurement is designed according to the common 2-pole signal fan, and most fans are 2-pole signal)
Stop Alarm Speed: Lower than 375rpm
Circuit Size: Approx. 65x65x15mm/2.56x2.56x0.59in
Positioning Hole Center Distance: Approx. 56x56mm/2.21x2.21in
Diameter: Approx. 3.2mm/0.13in