ENC28J60 Ethernet LAN Module for Raspberry Pi Zero – 6.5x3cm Network Adapter

ENC28J60 Ethernet LAN Module for Raspberry Pi Zero – 6.5x3cm Network Adapter Description

ENC28J60 Ethernet LAN Network Adapter Module for Raspberry Pi Zero Board

Features:

Due to the for Linux system for Raspberry Pi Zero, the Pi Zero without NIC is
inconvenient.


However, most of operations are based on for linux's command
line via ssh service, so a Network Adapter is required.


The Pi zero
Enc28j60 is a simple Network Adapter module for Raspberry Pi zero.


It
allows for Raspberry Pi zero to access the network smoothly, and it is
easy to do system updates and software installation operations.


Easy to assemble, easy to setup, official OS overlay support, stable and fast.


Specifications:
Compatibility: pi0 piw
Size: 6.5*3cm/2.5*1.1in
Weight: 19g(approx.)
How to configure it:
1. Install the NIC module into for raspberry Pi.
2. Connect the network cable to ensure that your router supports DHCP and works well.
3. Burn the Raspbian image to TF card.
4. Edit the /boot/config.txt file by your favorite editor such as "nano" or "vim.tiny", and add the following parameter:
dtoverlay=enc28j60
Then save the exit and reboot for raspberry Pi.
NOTE: The module is tested only in raspbian environments.Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.
How to check if network adapter works well:
Open a terminal and typing this command:
ifconfig
Package Includes:
1 x Enc28j60 Network Adapter Module