Grbl CNC Z- Router Mill Touch Plate Tool

Grbl CNC Z- Router Mill Touch Plate Tool Description

The function of the tool setting instrument The measurement and compensation of the tool offset value in five directions can effectively the error and inefficiency caused by manual tool setting. No matter what kind of cutting tool is used for workpiece contour turning or milling, all tool tip points or tool lines involved in cutting must be adjusted or compensated so that they are accurately located at the same theoretical point or of the workpiece coordinate system on-line
How to use:
1.Alligator clip is fixed on the cutter
2. port has been connected to the control board (A5 interface on the 3018pro control board)
3.Place (plastic + aluminum plate) under the tool

material: plastic
Color as shown
GRBL Z-probe CNC Router Tool Setting Automatic Tool Setter. Thickness: 1.6mm (0.03mm)
Tool Setting Function It can accurately locate the working , and is most suitable for PCB engraving.
Easy to Use You can refer to our video to understand how to use it correctly.
Probe Please change the Probe in Grbl to: G91G21G38.2Z-30F100;G92Z1.6;G0Z5F10
What does G91G21G38.2Z-30F100;G92Z1.6;G0Z5F10 mean:
G91: Use relative coordinate mode
G21: Use mm unit
G38.2: Tool setting instruction
Z-30: The Z moves 30mm in the negative direction, if it touches the tool setter, it stop and set this point as the
F100: the speed of the Z- when it is running
;: , next instruction
G92: Coordinate offset, because the tool setter has a thickness, in order to remove the thickness of the tool setter, you need to set the offset
Z1.6: Z- offset 1.6, 1.6 is the thickness of the tool setter, which is subject to the actual measured thickness of the tool setter
;: , next instruction
G0: fast moving
Z5: The Z moves to the position of coordinate 5, which is convenient for taking out the tool setter
F10: Z- upward movement speed

Package Contents:
1 x Z- Router Mill Touch Plate set

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.