Pump Collar for Sand Filter 11380 - Compatible with Intex 12" and 14" Sand Filter Pumps

Pump Collar for Sand Filter 11380 - Compatible with Intex 12" and 14" Sand Filter Pumps Description

Maintain a secure connection between your Intex pump and sand filter with this robust replacement collar. Designed specifically for above-ground pool sand filters, this hose clamp ensures a reliable seal and durable hold for optimal filtration performance. Key Features: Guaranteed Compatibility: Designed to match original part 11380, compatible with Intex 12-inch (30 cm) and 14-inch (36 cm) diameter sand filters. Robust Design: Made of reinforced plastic that is resistant to UV rays, pool chemicals, and weather variations. Optimized Seal: Ensures a watertight connection between the pump and sand filter, preventing water leaks and pressure loss. Simplified Installation: Ergonomic design allows for easy tightening and loosening, generally without specialized tools. Economical Solution: An affordable alternative to replace a broken, lost, or damaged hose clamp, avoiding the costly replacement of the entire pump and filter assembly.

Compatible Applications:

Intex 12-inch sand filters (2800-3500 GPH models)

Intex 14-inch sand filters (3000-4500 GPH models)

Filtration pumps compatible with part number 11380

Replacement of worn or damaged original hose clamps

Recommended Replacement Instructions:

Turn off the pump and disconnect the power.

Release system pressure via the filter's relief valve.

Carefully loosen the old clamp and separate the pump from the filter.

Clean the sealing surfaces on both sides of the connection.

Position the new 11380 clamp onto the fitting, then Reconnect the pump to the filter.

Tighten the clamp evenly until it is secure but not overtightened.

Check for leaks before restarting the pump.

Technical Specifications:

Reference: Compatible 11380

Material: Reinforced ABS Plastic

Compatible Diameters: 12 inches (30 cm) and 14 inches (36 cm)

Type: Sand Filter Pump Clamp

Package Contents:

1 Sand Filter Pump Clamp (Reference 11380)

Important Compatibility Note:

This product is a universal compatible replacement accessory. It is not manufactured, sponsored, or affiliated with Intex.

Reference 11380 is used for identification and cross-referencing purposes only. It is essential to verify the exact match with your sand filter model before purchasing. Maintenance Tip: Regularly inspect the condition of the collar and associated gasket. Avoid overtightening, which could damage the plastic. Replace immediately if any cracks or deformation appear. Ensure the longevity of your filtration system with this 11380 replacement collar-a simple yet crucial part for a leak-proof and lasting connection between your Intex pump and sand filter!