Rust-Oleum NR1 Green Paint Stripper - 750ML

• Ideal for quick removal of layers of old paint and glue
• Developed to remove all types of oil-based and alkyd-based paints, emulsion paints, varnish and most two-component materials from metal, mineral and wooden surfaces
• Does not contain methylene chloride, NMP, acids, alkalis, biocides and conservation additives
• Works at low temperatures
• Will not affect metal, mineral or wooden substrates
• May affect plastic materials e.g. PVC, polystyrene - if in doubt patch test before use
• Pack size: 750ml

Highly effective paint remover for all paint types and glue without methylene chloride.

Nr. 1 Green Paint Stripper can be used for a quick removal of layers of old paint and glue. Green Paint Stripper is developed to remove all types of oil- and alkyd based paints, emulsion paints, varnish and most two-component materials from metal, mineral and wooden surfaces. Does not contain methylene chloride, NMP, acids, alkali's, biocides and conservation additives. It will not affect metal, mineral or wooden substrates.

Density (g/cm³): 0,99

VOC Level: 900 g/l

Propellant: Dimethyl ether.

Shelf Life: 1 year (can) and 2 years (aerosol) from date of production in unopened cans, if stored in dry, well ventilated areas, not in direct sunlight at temperatures between 5°C and 30°C.

Yield: 2 to 3m² per 500ml Aerosol; 2 to 4m² per litre.

Coverage Depends on many factors such as type of old coating and shape of the substrate and material losses during application.

Surface Preparation: Remove loose coatings as much as possible by scraping.

Please refer to the product Data Sheet for more technical information.

Nr. 1 Green Paint Stripper may affect plastic materials like e.g. PVC, polystyrene. In case of doubt, try on a small test patch beforehand.

To release possible pressure open the can carefully.

Remove loose coatings as much as possible by scraping. Temperature of air, substrate and material between 0°C and 30°C and relative humidity below 85%.

• Apply Green Paint Stripper thickly in an even layer with a brush (disposable brush, flat or round)
• Do not use synthetic brushes
• Allow to stand for 10 to 15 minutes, and remove the old layer with a filling knife or paint scraper
• Thick layers of some (two-component) products may need an additional treatment
• After use, clean the surface with a cleaner (f.e. ND 14), high pressure (steam) cleaning, fresh water and allow to dry completely before applying a coating

Please refer to the product Data Sheet for further details.

Consult Safety Data Sheet and Safety Information printed on the can prior to use.

Ensure appropriate PPE is used - suitable gloves, protective eye goggles etc.

Please note the following hazards:

• Highly flammable liquid and vapour
• Do not use in the immediate vicinity of flames, hot surfaces or welding works
• No smoking
• Consult Safety Data Sheet and Safety Information printed on the can prior to use
• Attention! Open the can carefully to release possible pressure