(Silver, 5 Litre) Stove Fire Pit BBQ Paint Heat Resistant Up To 600C

(Silver, 5 Litre) Stove Fire Pit BBQ Paint Heat Resistant Up To 600C Description

Guard HT

Silicone heat resistant paint for metal

• Single component coating
• Heat resistant
• Interior and exterior 
• For use on metal e.g. stove, BBQ, fire pit, fireplace, engine, exhaust
• Suitable for operating temperatures up to 600°C
• Finish: Flat

Product Description

Guard HT is a single component, silicon heat resistant paint ideal for interior and exterior use on metal, at operating temperatures up to 600°C.

Product Uses

• Stoves
• Fireplaces
• Chimneys
• Smoke channels
• Burners
• Engines
• Exhaust systems
• Barbecues
• Sauna heaters
• Other metal substrates with operating temperatures up to 600° C
• Interior use
• Exterior use

Further Details and Technical DataTechnical Data

• Theoretical spreading rate: 6m2p/l approx.
• Volume Solids: 9% 
• Dry Film Thickness (DFT): 15μm
• Wet Film Thickness (WFT): 170μm
• Flash Point: Above 21°C
• VOC Content: 580 gms/litre
• Touch Dry: 1-2 hours
• Recoatable: 2 hours
• Hard Dry: Needs to be cured at 200°C for 1 hour to obtain full cure
• Storage: Keep material in original containers and use within 12 months of delivery. Materials not used should be resealed. Store in a cool, dry place and at temperatures no lower than 10°C.

Surface Preparation

Ensure surfaces are clean, dry and free from grease and other contamination before coating. Thoroughly degrease and where applicable, abrade to remove rust and promote good adhesion of the coating. Complex structures may be more effectively cleaned by detergent pressure washing or steam cleaning.

For optimum corrosion protection, mild steel should be blast cleaned to ISO Sa2.5.

Application

• Brush
• Roller
• Airless Spray (thin if necessary)
• Conventional Spray (thin if necessary)

Note: In order to achieve the recommended DFT, additional coats may be required depending on the equipment used, spraying techniques and substrate profile.

Thinner

Guard Solvent A.

Precautions

Materials are both hazardous and flammable and therefore precaution measures should be taken and appropriate P.P.E worn in accordance with the Material Safety Data Sheets and regulations.

Safety

• Ensure appropriate PPE is worn - gloves, protective eye goggles, mask etc. Contact us for advice.
• Please view the product Health & Safety Sheet for information in relation to hazardous identification, first aid measures, fire fighting, accidental release, handling, exposure control, personal protective equipment (P.P.E), disposal and regulatory information.