Upgraded -H Vector Network Antenna Analyzer

Upgraded -H Vector Network Antenna Analyzer Description

1. Lower power supply noise, less noise when using harmonics;
2. Built-in 400mAh battery
3. Add a Micro-SD card to save the ;
4. Add RTC support;
5. Modify the port names to Port1 and Port2

Measurement Frequency: 10KHz -1.5GHz
Output: -13dbm (maximum -9dbm)
Frequency Accuracy: Less than 0.5ppm
Measurement Range: 70dB (50kHz-300MHz), 50dB (300M-600MHz), 40dB (600M-900MHz) enable extended firmware)
Port SWR: Less than 1.1
Display: 2.8 inch TFT (320 x240)
USB Interface: USB Type-C; Communications Mode: CDC (Serial)
Power Supply: USB 5V 120mA, built-in 650mAh electricity, maximum charging current 0.8A
Number of Calibration Points: 101 (Fixed)
Number of Scanning Points: 101 (Fixed)
Display Tracking: 4, Marking: 4, Save Setting : 5
Measuring S parameters, voltage standing wave ratio, phase, delay, chart and the like
Colour:black
Material:Metal + Plastic

Package Contents:
1 x host (including 2.8-inch touch screen, 400mAh battery)
2 x 20cm SMA male to male RG174 cable
1 x SMA female to female connector
1 x SMA Simple Calibration Kit SHORT
1 x SMA Simple Calibration Kit OPEN
1 x SMA Simple Calibration Kit LOAD
1 x USB Type-C data cable
1 x Touch pen
1 x Picks

Only the above package content, other products are not included.
Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.