Upgraded Version of Antenna Vector Network Analyzer MF HF VHF

Upgraded Version of Antenna Vector Network Analyzer MF HF VHF Description

Lower Power Supply Noise, Smaller Noise When Using Harmonics;
Built-In 400mah Battery, Micro-Sd Supports Up To 32gb, And Only Supports Spi Mode.
Add A Micro-Sd Card To Save ; This Is A Diy Product That Provides As Complete A Vector Network Measurement Function As Possible In A Credit Card Size. Contains A 2.8-Inch Touch Screen, 400mah Battery, Tx/Rx Mode Measurement, And Can Measure Complete S11 And S21 Parameters. If You Need To Obtain S12 And S22, You Need To Manually Change The Transceiver Port Wiring.
Add Rtc Support;
Modify The Port Names To Port1 And Port2

Description:
1. Measurement Frequency: 50KHz ~ 1.5GHz
2. Output: -13dbm (Maximum -9dbm)
3. Frequency Accuracy: Less than 2ppm
4. Frequency Stability: Less than 0.5ppm
5. Measurement Range: Measurement Range: 70db (50khz-300 Mhz), (50db (300m-900mhz), 40db (900m-1500mhz));
6. Port Swr: Less than 1.1
7. Display: 2.8-Inch Tft (320x240)
8. Usb Interface: Usb Type-C Communication Mode: Cdc (Serial)
9. Power Supply: Usb 5V 120mA, Built-In 400mAh Battery, Maximum Charging Current 1a, Can Be Used Continuously For More Than 4 Hours
10. Number Of Calibration Points: 101 (Fixed)
11. Number Of Scanning Points: 101 (Fixed)
12. Display Traces: 4, Markers: 4, Settings Saved: 5
color: Black
Material: ABS

Package Contents:
1 x Host (Including 2.8-Inch Touch Screen, 400mAh Battery)
2 x 20cm SMA Male To Male RG174 Cable
1 x Type-C To Type-C Cable
1 x USB Type-C Data Cable
1 x Touch Pen
1 x Pick
1 x SMA Simple Calibration Kit Load
1 x SMA Simple Calibration Kit OPEN
1 x SMA Simple Calibration Kit SHORT
1 x SMA Female To Female Connector
Note:
Different Batches May Have Differences In Product Appearance, Color, And Printed Characters, Which Not Affect The Use

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.