(White) Performix Plasti Dip Rubber Coating Spray Paint Aerosol Can 325ml

(White) Performix Plasti Dip Rubber Coating Spray Paint Aerosol Can 325ml Description

Don't let any surface slow you down - Plasti Dip is the spray paint that adds vivid, neutral or low-key colour and a robust rubber coating to metal, fibreglass, rubber, concrete and more. Adding rich colour and a solid finish to anything you turn its nozzle to, Plasti Dip is a solid choice for fast, long-lasting results.

From car customising to home DIY, hobbyist recolouring or big art projects, Plasti Dip is resistant to rain, acid, abrasion and all of life's little knocks and scrapes. The firm rubber coating applied during the spray painting process offers a resilient layer of protection to your project, whatever it may be.

The resilience of Plasti Dip extends to temperatures, too. The rubber coating you create with this spray will weather both a sub-zero thermometer plunge and heat of up to 93 Celsius without a hint of peeling or damage. Light in the hand and easy to layer for a thick finish, Plasti Dip offers both colour and protection where you need it most.

Manufacturer's description:

Plasti Dip is an air-dried flexible liquid matte coating for use on virtually anything!

PlastiDip resists alkaline, acids, salts, moisture, abrasion, and most chemicals, and is an insulating dielectric coating. It will not crack, chip or peel, and will remain flexible even under severe conditions (-34ºc to +93ºc).

PlastiDip can be dipped, brush coated and sprayed. Add more layers for greater protection and grip.

Also... plastic, rubber, fibreglass and concrete surfaces!

Guide to Preparation and Application:

The essential criteria is to ensure the surface is squeaky clean, grease, dirt, debris and contaminant free and thoroughly dry before coating.

On vehicles or irregular shaped items, particular attention should be paid to the sills, trim, gutters, grills, any tight or hard to get to corners and gullies that you would not normally concentrate on.

Wash only with hot water as some soap detergents contain residues that Plasti Dip may not adhere to.
Never use any petroleum, citric, alcohol or solvent based cleaning/care products with Plasti Dip. Do not use car care cleaning products such as wheel shines, paint wipes etc, as these often leave trace residues which could cause adhesion problems.

Remove all traces of previous wax or silicone residue from cleaning products using the correct de-greaser, particularly for metal and plastic surfaces.

Refer to aerosol for instructions. Shake well before and during use. Test spray pattern on sample piece prior to application. In cold conditions, place aerosol in warm water (approximately 21°c) for 10-15 minutes before use.