Adjustable Flame Jet Lighter with Long Nozzle - Camping & BBQ Essential

Adjustable Flame Jet Lighter with Long Nozzle - Camping & BBQ Essential Description

Portable Straight Jet Cigar Torch Lighter Barbecue Welding Torch Jet Flame Lighter Black Red
Item Type: Portable Straight Jet Cigar Torch
Material: Shell Material: ABS, Zinc Alloy
Gross Weight: 140g / 4.9oz
Color: Black Red
Commodity Use: ignition torch
Commodity Size: Approx.52 x 130 x 86 x 30mm / 2.0 x 5.1 x 3.4 x 1.2in
Surface Treatment: metal painting
Product Fuel: butane
Commodity Parameters: ignition performance: 360 degrees inverted ignition; flame temperature: about 1300
Adjust the flame:
1. When in use, the flame height will change to a certain extent with the decrease of the gas content of the product and the change of the ambient temperature. This is a normal phenomenon. You can adjust the flame height appropriately;
2. During use, the normal flame height shall be adjusted at:
Wind proof and direct impact lighters are 1.5-2.5cm; 2.5-4.0cm for aloud, gasoline and open flame lighters;
3. If you need to adjust the flame height, please use a slotted screwdriver to aim at the slot of the flame regulator; If the lighter itself is equipped with an adjusting ring, you can directly use your fingers to adjust it to turn clockwise in the direction of the negative arrow to lower the flame height;
Turn it counterclockwise in the direction of the positive arrow to increase the flame height.
4. The gasoline lighter shall control the flame height by adjusting the height of the ignition wick. If the flame height is too high, a little of the wick can be cut off with scissors;
If the flame height is too low, pull out the wick properly.
Gas filling method:
1. During gas filling, there must be no sparks or kindling around to ensure safety. Do not add gas while smoking;
2. Qualified butane gas shall be used. Poor gas may damage the lighter or reduce its service life;
3. When filling gas for ordinary models, stand the lighter upside down, align the gas bottle and cover the air inlet of the lighter, press it several times with force, and keep it for about 2 seconds each time; If the gas cannot be filled, it may be that there is excess air left in the gas box. At this time, you can deflate the gas vertically. At this time, use a small screwdriver to aim at the air inlet and quickly deflate the gas for 1-2 times, and then perform the gas filling operation upside down;
4. When refueling with gasoline, open the head cover, pull out and reverse the movement, lift the outer sponge and add a proper amount of gasoline. After the gasoline seeps into the inner cotton, cover the outer sponge and put it into the casing;
5. After replenishing fuel for various lighters, wait at least one minute to adjust the temperature of the newly filled gas to room temperature, and ignite after the residual gas attached to the surface of the lighter has volatilized completely. If the ignition operation is carried out immediately at this time, the residual gas on the surface of the lighter may be ignited, causing unnecessary danger. After replenishing gas, if the flame height is too high or too low during use, it is normal, and the flame height can be adjusted appropriately.