Automatic Touchless Toilet Flush Kit with 20” Sensor Range, Supports Sensor Remote Control, Fits Lever-Style Toilets

Automatic Touchless Toilet Flush Kit with 20” Sensor Range, Supports Sensor Remote Control, Fits Lever-Style Toilets Description

Ridgesun Automatic Flush Toilet Conversion Kit with Wireless Sensor

Designfeatures

• Superior flushing with proven Infrared Object
• Easy to install on-wall sensor system
• Suitable for installation in a variety of toilets
• Installation in different locations allows for different functions. Very strong diy properties.
• LEDindicationondetection
• Sealedbaterycompartment
• Simpleinstalation,nospecialistrequired

3simpleparts,1simpleinstalation.

• Off-seat flushing
• Remote Control Flush
• Battery operated
• Simple installation / no specialist required

Off-seat flushing

Automatic flushing away from the seat by means of a sensor.

Remote Control Flush

The sensor can support manual press to flush.

No plug, battery powered

No outlets are needed, perfect for your bathroom remodel.

simple installation

No tools required, just open the tank and install it

Not closing the toilet lid

If you do not have the habit of closing the lid, you can adhere it to the underside of the lid to enable automatic flushing when leaving the toilet.

Close the lid and flush

If you are accustomed to closing the lid for flushing, you can adhere it to the front of the lid to enable automatic flushing.

nothing to do with the toilet seat.

Of course, you can also adhere it to the back wall of the tank to achieve the same function.

DIY

You can use your imagination to adhere them anywhere, transforming the toilet into a foot-operated, remote-controlled, and more.

Installation method

Completely CLOSE toilet's water supply stop.

Remove toilet tank lid and place flat on floor, away from work area.

Fasten the metal clasp.

Hang the FLUSH MODULE on the edge of the toilet tank.

Attach one end of the chain to the lever connection point.

Tighten the chain, this step is crucial. After tightening, insert one hole of the chain into the plastic fixture on the rocker. Once installed, the chain should remain tightened at all times.

Connect the main unit and the FLUSH MODULE using the venting fittings, and remove the protective film from the battery at the same time.

Install the assembled battery box on the drain valve, or alternatively, hang it on the edge of the toilet tank using the metal piece.

Reopen the water valve and wait for the tank to fill with water.

Remove the battery protection device, wait for 1 minute for the machine to pair, then press the sensor and observe the action inside the tank.