Dual Drive Controller Brushless Motion Module Industrial

Dual Drive Controller Brushless Motion Module Industrial Description

1、Widely used in DIY, industrial and automation fields such as joint flexible robots, robotic arms, 3D printing, camera gimbals, pan/tilt slides, CNC milling machines, ship models, and car models. 2、The supporting USB connection PC terminal can realize the motor debugging and complex Multi-axis control can realize FOC control for most brushless motors on the market. 3、With the use of encoder, it can also realize any torsion, speed loop, position loop, current loop, and position control based on trajectory planning. 4、The high-performance brushless drive is based on the open source project ODrive for hardware optimization and enhancement, with stable performance, and matching the original Odriver firmware. 5、Supported encoders include incremental encoder, absolute encoder, for Hall sensor, AMT102, AMT103, TLB5012, AS5047.
Item Type: Driver Board
Material: Plastic
Model: ODESC3.6 dual drive
PCB Layers: 4 layers
Applicable Voltage: 8-56V
Current Parameters: 50A continuous/120A peak
Support Encoder: Incremental encoder, absolute encoder, for Hall sensor, AMT102, AMT103, TLB5012, AS5047
Communication Interface: USB-protocol open source (for PC/ROS/Raspberry Pi), UART (embedded device), PWM (RC remote control), STEP/DIRECTION (PLC)/GPIO/CAN/ANALOG INPUT
Voltage Protection: Programmable voltage protection to prevent over-discharge of the battery
Movement Modes: Speed mode, torsion mode, current mode, position mode, trajectory mode, etc.
1 x Driver Board
1 x Power Resistance
1 x XT60 Male
1 x USB Data Cable
2 x 20AWG Power Resistance Wire
6 x Motor Wire(6pcs black wire)
2 x Power Cord(1pc red cord; 1pc black cord)