KQ-130F 220VAC Power Line Carrier Module Long Distance Data Com

KQ-130F 220VAC Power Line Carrier Module Long Distance Data Com Description

1、KQ-130F is a single row 9-pin small size high-performance zero carrier data transceiver module 2、Designed for on AC, strong interference, strong attenuation and long distance required environment, reliable data transmission 3、A frame continuous send maximum length is 252 bytes or less, from 1 to 252 defined by the user, and the module will not send redundant data 4、TVS diode protection against lightning stroke, the PCB wiring and components selection are all designed for wide temperature and high voltage resistance 5、Suitable for meter reading, street light, intelligent household, fire fighting, building control and other applications that need power to send data
Features:
KQ-130F is a single row 9-pin small size high-performance carrier data transceiver module.
Designed for on 220V AC, strong interference, strong attenuation and long distance required environment, reliable data transmission.
A frame continuous send maximum length is 252 bytes or less, from 1 to 252 defined by the user, and the module will not send redundant data.
TVS diode protection against lightning stroke, the PCB wiring and components selection are all designed for wide temperature and high voltage resistance.
Suitable for meter reading, street light, intelligent household, fire fighting, building control and other applications that need power to send data.
Specifications:
Working Frequency: 120~135KHZ
Connector Baud Rate: 9600bps
Actual Baud Rate: 100bps
One Frame Continuous Send Max. Length: 252 bytes (user defines from 1 to 252, module will not send redundant data)
Receive Sensitivity: 1mV
Out-of-band Rejection Ability: 60dB
Band Width: 10 KHZ
Insulation Resistance: 500V500MΩ
Power Supply: DC +5V(receiving: 11mA; sending: 230mA)
Operating Temperature: -25~70
Operating Humidity: 90%
Size: 5.3*4.5*1cm/2.08*1.77*0.39in
Weight: 30g(approx.)
Wiring:
1P---AC: 220V live wire (or neutral wire)
3P---+5V: +5V sending power supply(210mA), if only receiving data, can be disconnected to reducing power consumption
4P---GND: Digital circuit ground
5P---+5V: +5V working power supply 11mA
6P---RX: TTL level, carrier data input, connect to TXD of SCM
7P---TX: TTL level, carrier data output, connect to RXD of SCM
8P---MODE: Mode selection, connect to 5V as high level or disconnect, connect to ground as low level
9P---NC/RST: Reset pin(low level effective), for frequent switching modes. No connection if do not use this function.
Package Includes:
1 x Power-line Carrier Module
Note:Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.